Browsing by Author "Genc, Ozgur"

Now showing 1 - 2 of 2

Evaluation of Three Instrumentation Techniques at the Precision of Apical Stop and Apical Sealing of Obturation
(Univ Sao Paulo Fac Odontologia Bauru, 2011) Genc, Ozgur; Alacam, Tayfun; Kayaoglu, Guven
Objective: The aim of this study was to investigate the ability of two NiTi rotary apical preparation techniques used with an electronic apex locator-integrated endodontic motor and a manual technique to create an apical stop at a predetermined level (0.5 mm short of the apical foramen) in teeth with disrupted apical constriction, and to evaluate microleakage following obturation in such prepared teeth. Material and Methods: 85 intact human mandibular permanent incisors with single root canal were accessed and the apical constriction was disrupted using a #25 K-file. The teeth were embedded in alginate and instrumented to #40 using rotary Lightspeed or S-Apex techniques or stainless-steel K-files. Distance between the apical foramen and the created apical stop was measured to an accuracy of 0.01 mm. In another set of instrumented teeth, root canals were obturated using gutta-percha and sealer, and leakage was tested at 1 week and 3 months using a fluid filtration device. Results: All techniques performed slightly short of the predetermined level. Closest preparation to the predetermined level was with the manual technique and the farthest was with S-Apex. A significant difference was found between the performances of these two techniques (p<0.05). Lightspeed ranked in between. Leakage was similar for all techniques at either period. However, all groups leaked significantly more at 3 months compared to 1 week (p<0.05). Conclusions: Despite statistically significant differences found among the techniques, deviations from the predetermined level were small and clinically acceptable for all techniques. Leakage following obturation was comparable in all groups.
Influence of Powdered Dentin on the Shear Bond Strength of Dentin Bonding Systems
(Japanese Soc dental Materials devices, 2012) Eliguzeloglu Dalkilic, Evrim; Genc, Ozgur; Ozcopur, Betul; Belli, Sema; Eskitascioglu, Gurcan; Ozcan, Mutlu
This study evaluated the effect of different amounts of dentin powder (DP) mixed in Clearfil SE Bond (CSB) or Single Bond (SB) on adhesion to dentin. Human third molars (n=96) were sectioned to expose the mid-coronal dentin and divided into eight experimental groups (n=12 per group), namely, Group 1: CSB, Group 2: CSB+1.5 mg DP, Group 3: CSB+3 mg DP, Group 4: CSB+4.5 mg DP, Group 5: SB, Group 6: SB+1.5 mg DP, Group 7: SB+3 mg DP, and Group 8: SB+4.5 mg DP. Filtek Z250 composite was bonded onto dentin, and all specimens were subjected to shear bond strength test at a crosshead speed of 1 mm/min. Highest bond strength was obtained in Groups 1, 2, and 3 (15.1, 13.5, and 16.4 MPa respectively; p>0.05) and the lowest in Groups 6, 7, and 8 (5.5, 5.6, 4 MPa; p>0.05). DP addition, regardless of amount, adversely affected the bond strength of SB. Bond strength of CSB was not affected when 1.5 or 3 rag of DP was added.