Effects of Sinuosity Factor on Hydrodynamic Parameters Estimation in Karst Systems: a Dye Tracer Experiment From the Beyyayla Sinkhole (Eskisehir, Turkey)

Abstract

The sinuosity factor (SF) is a critical value in karst systems in terms of estimating their hydrodynamic parameters including groundwater velocity, coefficient of dispersion, etc., through dye tracer experiments. SF has been used in a number of different dye tracer experiments in karstic systems to estimate a representative flow path. While knowing SF is crucially important in the estimation of hydrodynamic parameters, its calculation is associated with significant uncertainty due to the complexity of subsurface karstic features. And yet, only a few studies have discussed its uncertainties, which might lead some errors in estimation of hydrodynamic parameters from dye tracer experiment. In this study, dye tracer experiments were conducted in two consecutive years (2003 and 2004) representing low and high flow conditions in the Beyyayla sinkhole (Eskisehir, Turkey) where the flow path is well known. Uranine was used in experiments as a tracer and QTRACER computer program was used to determine the hydrodynamic properties of the Beyyayla karst system as well as to gain insights into the effects of SF from dye tracer experiments on estimated parameters. The results showed that the breakthrough curve follows a unimodal and a bimodal distribution in low and high flow conditions, respectively. These different distributions stem from the water transport mechanisms, where velocities were calculated as 58.2 and 93.6 m h(-1) during low and high flow conditions observed in a spring emerging from the south side of the studied system. The results also show that the coefficient of dispersion, Reynolds number, and Peclet number increased and longitudinal dispersivity decreased with the higher flow rate. Furthermore, the estimated parameters did not vary with either the flow conditions or the tracer transit time, but they have shown some variations with SF. When SF was increased by 50 %, a change in these parameters was obtained in the range of 50-125 %.